아날로그 전압 - PWM 신호 변환 모듈 -OPA2365, TLV3201
(AN TO PWM CLICK)
개요
- 본 제품은 아날로그 전압 -PWM 신호 변환 모듈입니다.
- 아날로그 전압 입력을 고정된 주파수의 PWM 전압 출력으로 변환하여 주는 제품으로 duty cycle은 입력 전압에 비례합니다.
- 리니어한 반응성을 가진 출력을 가지고 있으며, -2.5V에서 2.5V의 전압 신호를 입력하면, 0-100%의 PWM 출력을 출력합니다.
- 5V 로직에서 사용이 가능합니다.
-
특징
-
HOW DOES IT WORK?
AN to PWM Click is a device that converts an analog voltage input signal into a pulse width modulated (PWM) output signal. This Click board™ consists of an analog circuitry, made of two comparators and two op-amps, needed for the described device. Op-amps used on this Click board™ are OPA365 series, while comparators used are TLV 3201, both from Texas Instruments. It has a linear response, so applying a voltage in a range of -2.5 to 2.5V on its input, will result in generating the PWM pulse train with duty cycle linearly proportional to the input voltage.
This circuit on this Click board™ utilizes a triangle wave generator and comparator to generate a pulse-width-modulated (PWM) waveform with a duty cycle that is inversely proportional to the input voltage. An op amp and comparator generate a triangular waveform which is passed to the inverting input of a second comparator. By passing the input voltage to the non-inverting comparator input, a PWM waveform is produced. Negative feedback of the PWM waveform to an error amplifier is utilized to ensure high accuracy and linearity of the output.
One op-amp (U1a) and one comparator (U3) are used in order to form the triangle wave generator. The error amplifier, composed of one op-amp U1b, serves two purposes. First, the error amplifier accommodates feedback of the output PWM waveform in order to correct for any errors in the output voltage introduced by the comparator on the output of the circuit (U2). Second, it adds a dc offset to the input voltage so that negative input voltages can be accommodated by the circuit. That way, in case that input signal is equal to 0V, the value of PWM duty cycle on the output is 50%.
The output PWM signal on the AN to PWM Click is brought to the INT pin of the mikroBUS™ socket, in order to enable fast and precise duty cycle measurement, using the interrupt routines. The frequency of the PWM signal is fixed to 500kHz.
This Click Board™ is designed to be operated only with 5V logic level. A proper logic voltage level conversion should be performed before the Click board™ is used with MCUs with logic levels of 3.3V.
-
Type Measurements Applications AD conversion, inspection, test and measurement equipment, while it can also be used as the variable clock signal generator. On-board modules OPA2365 – Dual 50MHz, Low-Noise, Single-Supply Rail-to-Rail Operational Amplifier; TLV3201 - 40-ns, microPOWER, push-pull output comparator, both from Texas Instruments. Key Features Very good linearity, covers a positive and negative input voltage range and it has good temperature stability Interface GPIO Compatibility mikroBUS Click board size S (28.6 x 25.4 mm) Input Voltage 5V
