과전류 트리거 AC 전류 센서 릴레이 -ZMCT103C, 5A
(AC Current Sensor with Relay -ZMCT103C)
개요
- 본 제품은 과전류 트리거 AC 전류 센서 릴레이 -ZMCT103C입니다.
- 포텐셔미터로 설정가능한 전류값에 따라 AC 전류가 설정치보다 높게 되면 릴레이를 동작시키는 제품입니다.
- 5A까지 전류 센싱이 가능합니다.
- 장치를 과전류로부터 보호하고자 할 경우 사용하면 좋은 제품입니다.
특징
-
Working voltage: DC5V;Working current: <20MA;Current detection range AC 0.3-5A
문서
-
VCC: working voltage positiveGND: negative working voltage;ON: Normally open, NO and COM are disconnected before the relay pulls in, and short-circuited after pulling in;COM: public terminal, relay common interface;NC: Normally closed end, NC and COM are shorted before the relay pulls in, and disconnected after pullingThe overcurrent protection point is set by adjusting the potentiometer, where the clockwise adjustment reduces the detection current. Methods as below:Pass the wire under test through the current transformer, connect VCC and GND to DC1 2V power supply; adjust the potentiometer, when the sound of the relay pull-in is heard (use a multimeter to measure whether COM and NO are connected, if it is connected, the relay has been pulled in ), Then reduce or cut off the current flowing through the conductor under test. If the relay is released at this time, it means that the overcurrent protection point has been found.If the relay is not released when the current flowing through the conductor under test is reduced or cut off, it means that the potentiometer must be adjusted to find the overcurrent protection point.