LM66200 듀얼 다이오드 모듈 -멀티 전원 역전압 방지
(Adafruit LM66200 Ideal Dual Diodes Breakout)
개요
- 본 제품은 LM66200 듀얼 다이오드 모듈 -멀티 전원 역전압 방지입니다.
- 배터리나 DC 전원잭 혹은 USB 전원 등의 여러 전원을 끊김 없이 전환할때 역전압을 방지 하고자 할때 사용이 가능한 제품입니다.
특징
- Input voltage range: 1.6 V to 5.5 V
- Maximum continuous current: 2.5 A
- On-resistance: 40 mΩ (typical)
- Standby current: 50 nA (typical)
- Quiescent current: 1.32 μA (typical)
- Automatic diode switchover
- Controlled output slew rate: 1.3 ms (typical) at 3.3 V
- Reverse current blocking when VOUT > VINx
- Thermal shutdown
- Product Dimensions: 16.5mm x 10.0mm x 2.2mm / 0.6" x 0.4" x 0.1"
- Product Weight: 0.5g / 0.0oz
문서
-
Most projects these days have multiple power supplies: say a battery or DC wall plug or USB for multiple powering options. Juggling these to have seamless hot-swap while avoiding back-powering is always a bit of a challenge: you want to keep things small, cheap, low power and of course reduce as much voltage drop as possible.
The Adafruit LM66200 Dual Ideal Diode breakout is a cute solution to dual supplies: it has back-voltage protection, and two 'ideal' diodes with RdsOn of 40 milliohms, support for 2.5A continuous draw and a separate enable input and status output.
Sure you could DIY the circuitry with multiple transistors, but this is compact and easy to use! Simply connect the two 2~5V power supplies to Vin1 and Vin2, the higher of the two will appear on Vout. Disable the output completely by pulling the On/Enable pin high. Check the Status pin, if desired, to see whether Vin1 or Vin2 is the selected supply.
To make it bread-board friendly, we've placed it on a small PCB with 6 x 0.1" breakout pads. The chip and a 1 Megaohm enable-pulldown is soldered on top. We include a bit of header, some light soldering is required to attach the header - or use free wiring if you want to insert it directly into a circuit.