(Tic T249 USB Multi-Interface Stepper Motor Controller)
개요
본 제품은 Tic T249 USB 멀티 인터페이스 스텝모터 드라이버 입니다.
무료 소프트웨어를 이용하여 USB를 통해 쉽게 설정할 수 있으며, 6개의 인터페이스(USB, TTL serial, I²C, analog voltage (potentiometer), quadrature encoder, hobby radio control (RC))를 지원합니다.
TB67S249FTG 드라이버를 장착하고 있습니다.
10V-47V의 동작전압을 가지고 있으며, 방열판 없이 phase 당 약 1.8A의 전류를 전달할 수 있습니다.
특징
Open-loop speed or position control of one bipolar stepper motor
A variety of control interfaces:
USB for direct connection to a computer
TTL serial operating at 5 V for use with a microcontroller
I²C for use with a microcontroller
RC hobby servo pulses for use in an RC system
Analog voltage for use with a potentiometer or analog joystick
Quadrature encoder input for use with a rotary encoder dial, allowing full rotation without limits (not for position feedback)
STEP/DIR inputs for compatibility with existing stepper motor control firmware
Acceleration and deceleration limiting
Maximum stepper speed: 50,000 steps per second
Very slow speeds down to 1 step every 200 seconds (or 1 step every 1428 seconds with reduced resolution).
Selectable microstep modes up to 1/256-step resolution:
The Tic 36v4 supports full-step to 1/256-step modes
The Tic T825, Tic T834, and T249 support full-step to 1/32-step modes
The Tic T500 supports full-step to 1/8-step modes
Digitally adjustable current limit
Optional safety controls to avoid unexpectedly powering the motor
Input calibration (learning) and adjustable scaling degree for analog and RC signals
5 V regulator (no external logic voltage supply needed)
Optional limit switch inputs with homing capabilities
Optional kill switch inputs
STEP/DIR outputs for controlling external stepper motor drivers
