PWM - 전환 변환 모듈 - 0-10V

(PWM to Voltage Converter Module -0-10V)

개요

  • 본 제품은 PWM 신호를 전압으로 변환하여 주는 모듈입니다.
  • PWM을 0-10V의 전압신호로 변환합니다.
  • 동작 전압은 12V-30V이며, PWM 수신 주파수는 1Khz-3Khz입니다.

특징

  • 1>. Work Voltage:DC 12V-30V; (> 100MA)
    2>. PWM Receiver Frequency: 1KHZ-3KHZ
    3>. PWM signal input level range:
        The peak of 4.5V to 10V level. The short cap install in '5V'. This level is used for normal controller or 5V MCU
        The peak of 12V to 24V level, so inserted in 24V. The short cap install in '24V'. This level is used for normal PLC controller  
    4>. Conversion range:0%-100% PWM to 0-10V
    5>. Allowable error:5%

  • Hardware Interface:

    VCC DC 12V-30V
    GND Ground
    PWM Positive of PWM input signal
    GND Negative of input signal
    VOUT Output Voltage 0-10V
    GND Output Voltage Ground

  • PWM Signal Input level range:
    The peak of 4.5V to 10V level. The short cap install in "5V". This level is used for normal controller or 5V MCU
    The peak of 12V to 24V level, so inserted in 24V. The short cap install in ‘24V’. This level is used for normal PLC controller
    Conversion Range: 0%-100% PWM to 0-10V
    Allowable Error: 5%

문서

  • Operation instructions:
    After power on, without input signal, the output is 0V, so only input can output.

    The first time when the power is on, it is best to do a calibration debugging: Input a 50% duty ratio signal to PWM/GND and adjust the relative amplitude short cap.

    The frequency is 1KHZ-3KHZ, Measured VOUT and GND with a multimeter and it will display 5V.

    Adjust potentiometer to make sure display 5.00V on multimeter. This will calibrate your pulse signal to this module.

    When the frequency changes, the correspondences may be offset and need to be re calibrated.
    The output voltage can be adjusted by adjusting the duty ratio.
    The accuracy can be controlled by adjusting the potentiometer.

연관제품