블랙 매직 JTAG 프로브 -JTAG 케이블 및 시리얼 케이블

(Black Magic Probe with JTAG Cable and Serial Cable - V2.3)

개요

  • 본 제품은 ARM Cortex를 해킹 하기 위한 차세대 디버깅 툴입니다.
  • 기존의 SWD/JTAG 디버거와 다르게 OpenOCD나 STLink를 사용할 필요가 없습니다.
  • 대신에 USB-Serial 연결을 통해 에뮬레이트 되는 본 제품 자체가 GDB 서버 포트입니다.
  • USB-Serial 아답터 이기도 하기때문에 dual GDB + printf 디버깅이 가능하며, 보드의 소켓헤더를 타켓에 연결하여 사용 합니다.

특징

  • Please note that not all chips/targets are supported! Please visit the documentation page to see whether your favorite chip is in the list. As of this writing it supports the following but more are being added so check the link for the latest!

    • STM32 F0, F1, F2, F3, F4, F7
    • Atmel SAMD20/21, SAM3N/S/X/U, SAM4L, SAM4S
    • Nordic nRF51, nRF52
    • NXP LPC8xx, LPC11xx, LPC15xx, LPC43xx
    • TI LM3S, TM4C
    • Freescale KL25, KL27, KL02
    • Xilinx Zync-7000
    • Broadcom BCM2836 (Raspberry Pi 2)
    • SiLabs EFM32 and EZR32

    Comes with 1 x Black Magic Probe, a 0.05" pitch SWD/JTAG ribbon cable, and a 0.1" pin header serial cable

  • Features:

    • GDB server port without the need of special PC side software.
    • TTL level serial interface
    • SWD and JTAG support
    • Supports 1.7V up to 5V targets
    • Can provide 3.3V to the target (up to 100mA)
    • Semihosting support
    • Works on Linux, Mac and Windows
    • Works with Eclipse and other Integrated Development Environments
    • Supports STM32, LPC11, LM3S - full support list
    • DroneCode compatible

    The Black Magic Probe allows you to:

    • Load your application into the target Flash memory or RAM.
    • Single step through your program.
    • Run your program in real-time and halt on demand.
    • Examine and modify CPU registers and memory.
    • Obtain a call stack backtrace.
    • Set up to 6 hardware assisted breakpoints.
    • Set up to 4 hardware assisted read, write or access watchpoints.
    • Set unlimited software breakpoints when executing your application from RAM.

    Very Brief FAQ:

    • Is it normal that my Black Magic Probe is getting noticeably warm when in use?
      • Yes, the Black Magic Probe is drawing about 120mA under normal operations. This means it will warm up noticeably when in use.
  • JTAG Ribbon Cable Length: 150mm
  • 0.1" Pin Header-Compatible Serial Cable Length: ~145mm

문서

연관제품