3D 트레킹 및 제스쳐 센서 Flick HAT -라즈베리용

(Flick HAT – 3D Tracking & Gesture HAT for Raspberry Pi)

개요

  • 본 제품은 라즈베리 파이와 사용이 가능한 3D 트레킹 및 제스쳐 센서입니다.
  • 15cm 거리까지에서 제스쳐를 검출할 수 있으며, 원을 그리거나 손을 옆으로 미는 동작 등을 트레킹할 수 있습니다.
  • 근접 자기장을 이용하기 때문에 나무나 아크릴과 같은 재질 뒤에서도 센싱이 가능합니다(거리는 줄어들수 있음)
  • 제스쳐를 이용하여 장치를 제어하여 보세요.

특징

  • Compatible with Raspberry Pi A+, B+, 2B and 3B

    •Also works with Raspberry Pi Zero, Zero Wireless and all other Raspberry Pis with 40 GPIO pins (or compatible boards).

    •3D tracking

    •Gesture sensing up to 15cm

    •Touch and Tap sensing

    •Communicates with the Raspberry Pi via I2C

    •Full software libraries (fully open-source code)

    •No soldering required

    •Dimensions: 6.5cm x 5.6cm x 0.6cm

    •One line installer

    •Fully CE and FCC tested and approved

  • Chip: MGC3130 3D Tracking and Gesture Controller

  • Detection range: 0 to 15 cm in ideal circumstances

  • Temperature Range:-20℃ to +85℃

  • Position Rate:200 positions/sec

  • Spatial Resolution:up to 150 dpi

  • Proximity and Touch Sensing

  • Compatible with the Hillstar Development Kit over USB on PC in order to use with a computer or to program new firmware onto the board.

  • Available gestures: Swipe (east to west, west to east, north to south, south to north), tap and double tap (center, east, west, north, south), airwheel (clockwise, anti-clockwise) and touch (center, east, west, north, south)

  • Works even through the Flick HAT case

  • No detection blind spots

  • Low–power design

  • Technical Details

    Dimensions 130mm x 75mm x 25mm
    Weight G.W 195g    
    Battery Exclude

    Part List

    Flick HAT 1
    Plastic bolts 8
    Plastic spacers 4
    Stickers 3
    Info card 2

문서

연관제품