This pack contains:

• 2-Axis Joystick - add analog input to your project! Contains two independent 10K potentiometers (one per axis) for reporting the joystick's position, with wiring options for voltage or resistance outputs.
• Micro servo - classic little servo that can rotate approximately 180 degrees (90 in each direction). Use any servo code, hardware, or library to control!
• ​Full-Size Breadboard - In the past, we've used the half-size breadboard for a lot of Pi projects - but no longer! WIth 40 pins to break out, you're going to need some space - and that's why we're including a full-size breadboard in this pack.
• Premium Male/Male Jumper Wires - 20 x 6" (150mm) - These jumper wires are great for making wire harness or jumpering between headers on PCBs. We include the longer ones so they work well with the full-size breadboard.
• Assembled Pi Cobbler Plus - Breakout Cable - This is the soldered together version of our popular Pi Cobbler Plus Kit. Comes with a breakout board that's perfect for cobbling prototypes as well as a 40-pin GPIO cable for your Pi's pins.
• 5V 2A Switching Power Supply w/ 6' MicroUSB Cable - The 5V 2A power adapter is the perfect choice for powering your Raspberry Pi B+ with 2 Amps of current output, and an extra long cord.
• Assembled Adafruit BME280 Temperature & Humidity sensor - The assembled version of an Adafruit Instant Classic. This breakout board has a powerful BME280 sensor from Bosh that's good for environmental, temperature, and barometric pressure sensing. This version comes with headers already soldered on.
• Assembled Adafruit Mini 8x8 LED Yellow-Green Matrix w/I2C Backpack - The assembled version of our yellow-green 8x8 matrix and backpack combination. Fully tested and ultra bright!
• MCP3008 - 8 Channel 10-Bit ADC With SPI Interface - Easy to use, SPI enabled chip that's perfect for adding 8 channels of 10-bit analog input to your microcontroller or microcomputer project.
• 8GB MicroSD Card with NOOBS 2.0 - installed with the latest version of Raspbian.
• Electronic components:
  • 1x Photo Cell
  • 2x Breadboard Trim Potentiometer
  • 5x 10K 5% 1/4W Resistor
  • 5x 560 ohm 5% 1/4W Resistor
  • 2x Diffused 10mm Blue LED
  • 1x Electrolytic Capacitor - 1.0uF
  • 1x Ceramic Capacitor - 0.1uF
  • 2x Diffused 10mm Red LED
  • 2x Diffused 10mm Green LED
  • 3x 12mm Tactile Switches

Note: This kit does not include a Raspberry Pi 3 Model B! For a version of this kit that includes a Pi 3, click here.

Also note: ARM is supporting this kit with all documentation and information on their GitHub:

https://github.com/ARM-software/Cloud-IoT-Core-Kit-Examples