I2C 오존 센서 (0-10ppm)
(Gravity: I2C Ozone Sensor (0-10ppm))
개요
- 본 제품은 I2C 오존 센서입니다.
- 0-10ppm까지 측정이 가능한 센서로 I2C 출력을 가지고 있씁니다.
- 3.3V/5V 시스템과 사용이 가능하며 대략 2년간의 센서 수명을 가지고 있습니다.
- 아두이노, 라즈베리, ESP32와 쉽게 연결하여 사용이 가능합니다.
- 알림: 제품동작을 위해서는 최초 24-48시간의 워밍업 시간이 필요합니다.
-
특징
- Measuring ozone concentration in the environment
- Supports Gravity 4-Pin Interface
- Accurate Digital Output
- Detection Gas: Ozone
- Working Voltage: 3.3 ~ 5.5V DC
- Interface: Gravity-4Pin
- Output Signal: I2C output
- Measuring Range: 0 ~ 10ppm
- Resolution: 0.01ppm (10ppb)
- Warm-up Time: ≤3 minutes
- Response Time: ≤90 seconds
- Recovery Time: ≤90 seconds
- Working Temperature: -20 ~ 50 ℃
- Operating Humidity: 15 ~ 95% RH (non-condensing)
- Storage Temperature: -20 ~ 50 ℃
- Life:> 2 years (in air)
- Dimension(L x W): 37mm * 27mm/1.06*1.46 inches
- Weight:0.022Kg
-
Precautions
Do not plug or unplug sensors on the module.
It is forbidden to change or shift the installation state of electronic components. The module avoids contact with organic solvents (including silicone and other adhesives), coatings, pharmaceuticals, oils and high concentrations of gases.
The module cannot be completely encapsulated with resin material, and it cannot be immersed in an oxygen-free environment, otherwise the performance of the sensor will be damaged.
The module cannot be used in the environment containing corrosive gas for a long time. Corrosive gas will damage the sensor.
The module must not be subjected to excessive shock or vibration.
The module needs to be warmed up for about 24-48 hours after it is powered on for the first time. After the module is fully stable, it will be tested normally.
The white waterproof and breathable membrane of the sensor on the module is strictly forbidden to open, otherwise it is regarded as artificial damage.
Do not install the module in a strong convection air environment.
Do not place the module in high-concentration organic gas for a long time. Long-term storage will cause the sensor zero point to drift and recover slowly.
SHIPPING LIST
- Ozone Sensor module *1
- Gravity-4pin I2C Cable *1
- M3*10 Nylon post *4
- M3*5 Screws *8