iNet-511 BNC 와이어링 박스 -INet-600/601 USB DAQ용

(Wiring Box with 8 BNCs and Screw Terminals)

개요

  • 본 제품은 iNet-i600/i601 USB DAQ 디바이스를 센서와 쉽게 연결할 수 있게 하여 주는 BNC 와이어링 박스입니다.
  • i600/i601의 각 핀을 터미널 블럭이나 BNC 커넥터로 접근할 수 있게 하였으며, 전선 및 shunt resistor를 설치할 수 있게 디자인한 제품입니다.
  • 전선은 결선하여 양 옆으로 뺄수 있으며, 상판 및 하판 플라스틱이 나사로 고정되는 구조로 되어 있습니다.
  • 알림: 본 제품은 써모커플 연결에는 사용 할 수 없습니다.

특징

  • The i51x is of clamshell design with identical top and bottom plastic halves that mate via 3 bolts. Two captive 4-40 bolts secure the i51x to any i4xx card that has an Hd44 male connector. The i511 is 8.3 x 2.5 x 13 cm in size (3.3" x 1" x 5.3", d/w/h).
  • i51x Wiring Boxes

     

    #iNet-510 #iNet-511 #iNet-512
    Model Bnc Connectors Thermocouple Support 1/4 and 1/2 Bridge Strain Gage vRef/2 Support Individual Banks of Screw Terminals for each sensor
    i510 0 yes no no
    i511 8 no no yes
    i512 0 no yes yes

문서

  • How to Assemble & Install i51x Wiring Box
  • How to attach i51x Wiring Box to i60x Standalone USB Device
  • i511 Electrical Schematic
  • i511 Pcb Picture
  • i51x Mechanical Drawing

  • Wiring to BNC's
    The i511 BNC Wiring box provides 8 BNC connectors at the front panel. The BNC center pin (Bnc+) and outter metal shell (Bnc-) route to screw terminals in the wiring box; as shown below.

    The user is responsible for wiring these BNC's to instruNet I/O channels, as needed. The i511 is shipped with factory installed jumper wires that connect the 8 BNC's to Channels 1/2, 3/4 .. 15/16. Also, for each BNC, the unit is shipped with a jumper wire that connects BNC- to instruNet ground. These jumpers are shown in the above illustration as dotted pink lines. Obviously, the end user can easily adjust the factory configured jumpers as needed. In many cases, the factory installed jumpers are exactly what the end user needs, yet not always. To see a photo of these jumpers and the labeling on the PCB, click here.

연관제품