Compatible with Raspberry Pi, BeagleBone, Arduino, Genuino or any I2C enabled device

•3D tracking

•Gesture sensing up to 15cm

•Touch and Tap sensing

•Communicates with the Raspberry Pi via I2C

•Full software libraries (fully open-source code)

•No soldering required

•Dimensions: 14.8 cm x 10.4cm x 0.5cm

•Level shifting chip to enable board to work with 3V3 or 5V0 power and logic

•Orange/green dual colour LED on board

•One line installer

•Fully CE and FCC tested and approved

Chip: MGC3130 3D Tracking and Gesture Controller

Detection range:0 to 15 cm in ideal circumstances

Temperature Range:-20℃ to +85℃

Position Rate:200 positions/sec

Spatial Resolution:up to 150 dpi

Proximity and Touch Sensing

Flick Large has a red/green dual colour LED that can be driven using pins LED1 and LED2

Flick Large has level shifting on board so can work with any microcontroller with either 5V or 3V3 power and data signals

Compatible with the Hillstar Development Kit over USB on PC in order to use with a computer or to program new firmware onto the board.

Available gestures: Swipe (east to west, west to east, north to south, south to north), tap and double tap (center, east, west, north, south), airwheel (clockwise, anti-clockwise) and touch (center, east, west, north, south)

Works even through the Flick Large case

No detection blind spots

Technical Details

Part List